Understanding Building Nymph Part 3
Exploring Building Nymph Part 3 reveals several interesting facts. Cutting out the side panels and doing the edge bevels and marking for the wire holes and the edges of the 2" and
Key Takeaways about Building Nymph Part 3
- Fishing 2 or
- Adding the outside wooden rails to the hull.
- Adding the bow and transom panels, and more on using bolts, washers, and nuts to hold the panel edges in alignment.
- Launch day for the
- More on wiring the hulls together, and laying out and cutting out the bow and transom panels.
Detailed Analysis of Building Nymph Part 3
Laying out the bottom panel curves, cutting out the bottom panel, and doing all the edge work for the drill holes and glass tape. Wiring the side panels to the bottom panel, and drilling for the 1/4" bolts that hold the edges inline. This is the first
More work on the bow rails, and starting on the spacer block locations, and where the seat will go.
Stay tuned for more updates related to Building Nymph Part 3.
